Commercial & Industrial Compressed Air Piping
Commercial & Industrial Compressed Air Piping
REI Plumbing & Construction designs and installs compressed air piping for shops, warehouses, garages and light industrial buildings across Chicago, Cook County, DuPage County and the Northwest Suburbs. We pipe from your compressor and receiver to every point of use, laid out so the air reaching your tools is clean, dry and at the pressure you need.
A lot of compressed air systems grow one hose and one fitting at a time. The result is pressure loss, water in the lines and leaks you can hear across the shop. A properly piped system fixes all three, and it usually costs less to run.
What we install
- Main distribution lines, including loop systems that feed air from two directions to hold pressure at the far end of the building
- Drops to workstations, bays, machines and hose reels
- Drain legs and low-point drains so condensate collects where it can be removed instead of running into your tools
- Isolation valves so a section can be shut down for service without stopping the whole shop
- Point-of-use connections: filters, regulators and lubricators where your equipment calls for them, plus quick-connect outlets
- Tie-ins to new or relocated compressors, dryers and receiver tanks
- Extensions and re-pipes when you add equipment, reconfigure a floor or move into a new building
Sized for flow, not just pressure
The most common problem we see is undersized piping. The compressor gauge reads fine, but tools at the end of the line are starved. Air loses pressure over distance and through every fitting, and small-diameter lines lose it fastest.
Before we lay out a system, we look at:
- How much air your equipment uses and how much of it runs at the same time
- The pressure each tool or machine needs
- The length of the run and the layout of the building
- Where moisture will collect and where it can be drained
- Room for equipment you plan to add
From that we set the main line size, the layout (a straight run or a loop) and the drop locations. We’ll walk you through the piping material options for your application and budget.
Who uses compressed air piping
- Warehouses and distribution buildings running pneumatic tools, dock equipment and maintenance shops
- Fabrication, woodworking and machine shops
- Auto repair and fleet maintenance garages
- Light manufacturing and assembly with pneumatic equipment on the floor
- Warehouse conversions where a new tenant brings air-powered equipment into a building that was never piped for it
Compressed air is often one part of a larger buildout. We can handle it together with the restrooms, floor drains, gas piping and water service on the same job. See Commercial Plumbing and Commercial Gas Piping.
Installed and tested before you rely on it
Every new system is leak-tested before it goes into service. We’ll walk you through the valves and drains so your team knows how to isolate a section and keep the lines dry. Lines are pitched toward the drain points, and drops come off the top of the main so condensate stays out of your tools.
REI Plumbing is a licensed, bonded and insured contractor, holding City of Chicago Plumbing Contractor License SBC 188764 and Illinois Plumbing Contractor License 055-038335. We’ve worked from our shop at 4358 N. Milwaukee Ave. since 2006.
Working with owners, tenants and GCs
We take compressed air work directly from business owners and facility managers, and as part of a plumbing subcontract under a general contractor. We’ll coordinate with whoever is supplying your compressor and dryer, and we price the piping as a lump-sum scope.
General contractors can find bid details on our For General Contractors page.
Get a compressed air piping quote
Call (773) 368-5459, Monday through Friday, 7 AM to 5 PM. Or email info@reiplumbing.com with the address, a floor plan or sketch, and a list of the equipment that will run on air.
